DT RM Revision
- Created by: Purplepineapple26
- Created on: 06-05-14 20:02
View mindmap
- DT:RM
- Types of Circuit
- Series Circuit: if one bulb breaks the entire circuit breaks because the flow of Electrons cannot get through.
- Parallel Circuit: If one bulb breaks the others keep shinning. The bulbs are brighter because the electrons can use different routes.
- Basic Circuit: Has a switch, a bulb and a cell/battery.
- The Process of Soldering
- 1, Hold the soldering iron onto the PCB to heat it up. It is hot enough when the solder flows onto the copper, NOT the soldering iron.
- 2. Move the soldering iron towards the component leg and feed in the solder.
- 3. When the solder has filled in the hole on the circuit board, move the solder away then the soldering iron.
- Types of Circuit
Comments
No comments have yet been made