# Physics Required Practical: Waves

Includes;

- The Method (In Blue)

- Safety Notes (In Pink)

- Created by: user1234
- Created on: 28-03-19 17:35

View mindmap

- Physics Required Practical: Waves
- Method 1: Observing Waves in a Ripple Tank
- 1. Set up the ripple tank. A large sheet of white card or paper needs to be on the floor under the tank.
- 2. Pour water to a depth of about 5mm into the tank. Adjust the height of the wooden rod so that it just touches the surface of the water.
- 3. Switch on both the overhead lamp and the electric motor. Adjust the speed of the motor. Low frequency water waves need to be produced.
- 4. Adjust the height of the lamp. The pattern needs to be clearly seen on the card on the floor.
- 5. Place a metre ruler at right angles to the waves shown in the pattern on the card. Measure across as many waves as possible. Then divide that length by the number of waves. This gives the wavelength of the waves.
- 6. Count the number of waves passing a point in the pattern over a given time. Then divide the number of waves counted by 10. This gives the frequency of the waves.
- 7. Calculate the speed of the waves using the equation: wave speed = frequency x wavelength.

- 6. Count the number of waves passing a point in the pattern over a given time. Then divide the number of waves counted by 10. This gives the frequency of the waves.

- 5. Place a metre ruler at right angles to the waves shown in the pattern on the card. Measure across as many waves as possible. Then divide that length by the number of waves. This gives the wavelength of the waves.

- 4. Adjust the height of the lamp. The pattern needs to be clearly seen on the card on the floor.

- 3. Switch on both the overhead lamp and the electric motor. Adjust the speed of the motor. Low frequency water waves need to be produced.

- 2. Pour water to a depth of about 5mm into the tank. Adjust the height of the wooden rod so that it just touches the surface of the water.

- 1. Set up the ripple tank. A large sheet of white card or paper needs to be on the floor under the tank.
- Method 2: Observing Waves on a Stretched String
- 1. On a wooden bridge, set up a vibration generator connected to a power supply, with a string stretched across the top.
- 2. Switch on the vibration generator. The string should start to vibrate.
- 3. A clear wave pattern needs to be seen. To do this, adjust the tension in the string or move the wooden bridge to adjust the length of the string. The waves should look like they are stationary.
- 4. Use a metre ruler to measure across as many half wavelengths as possible. Then divide the total length by the number of half waves. Multiplying this number by two will give the wavelength.
- 5. The frequency is the frequency of the power supply. Calculate the speed of the wave using the equation: wave speed = frequency x wavelength.

- 4. Use a metre ruler to measure across as many half wavelengths as possible. Then divide the total length by the number of half waves. Multiplying this number by two will give the wavelength.

- 3. A clear wave pattern needs to be seen. To do this, adjust the tension in the string or move the wooden bridge to adjust the length of the string. The waves should look like they are stationary.

- 2. Switch on the vibration generator. The string should start to vibrate.

- 1. On a wooden bridge, set up a vibration generator connected to a power supply, with a string stretched across the top.
- Students sitting close to the vibrating string should wear safety goggles or sit behind a safety screen.
- The frequency of a stroboscope can trigger an epileptic fit.

- Method 1: Observing Waves in a Ripple Tank

## Similar Physics resources:

Teacher recommended

Teacher recommended

## Comments

No comments have yet been made