• Created by: dkoning00
  • Created on: 29-04-16 16:21
Define Heat
Heat is a measure of energy in an object on an absolute scale
1 of 85
What is heat measured in?
2 of 85
Why is heat measured on an absolute scale?
Because the value of a particles energy (movement) cannot go below 0
3 of 85
Describe how heat flows
Energy flows from a hotter medium to a cooler one to balance the temperature
4 of 85
Define Temperature
Temperature is a measure of the average kinetic energy of particles in a substance (how hot it is) measured on a scale that is not absolute
5 of 85
What is temperature measured in?
degrees Celcius, Fahrenheit, Kelvin etc.
6 of 85
Why is temperature not measured on an absolute scale?
Because temperature values can drop below 0 (freezing)
7 of 85
What is Specific Heat Capacity?
The amount of energy needed to raise the temperature of 1kg of a substance by 1 degree Celcius (how much energy it can store)
8 of 85
What is SHC measured in?
9 of 85
Give the equation for Specific Heat Capactiy
Energy = Mass x SHC x Temperature Change
10 of 85
How much energy is needed to heat 2kg of water from 10 to 100 degrees C? (SHC of water is 4200 J/kg/dC)
756 000 J
11 of 85
Describe the time-temperature graph involved with heating water from -20 to 120dC
Temp. rises from -20 to 0 then gradient goes flat (no temp change) as energy is used to break intermolecular bonds instead of raising the temperature. the same happens at 100 dC when boiling
12 of 85
Define Specific Latent Heat
The amount of energy needed to change the state of a substance without changing its temperature
13 of 85
Give the equation for SLH
Energy = Mass (kg) x SLH (J/kg) - (note, SLH is specific to each substance for one state change)
14 of 85
The SLH of water for melting is 334 000 J/kg. How much energy does it take to evaporate 200g of water? (remember to convert to the correct units)
66800 JList
15 of 85
List the three ways energy is transferred
Conduction, convection and radiation
16 of 85
How does energy travel by conduction?
Vibrating particles pass on kinetic energy to nearby particles to pass energy throughout a substance
17 of 85
Through what medium does conduction generally occur fastest? Why?
Solids because the particles are tightly packed
18 of 85
How does energy travel through liquids and gases by convection?
Particles with high relative energy move from the hotter region of a substance to the cooler region and take their energy with them before cooling and falling back to the hotter area
19 of 85
How does energy travel by radiation?
Electromagnetic waves carry energy without needing a medium
20 of 85
What surfaces best absorb and emit heat radiation
Matt Black
21 of 85
Describe how food is cooked in an oven
Heat is emitted as infrared waves by the black panels on the inside and reflects around making sure all the food is cooked
22 of 85
Describe how is food cooked in a microwave oven
Microwaves are emitted at the food penetrating roughly 1cm in and heating water and fat molecules only. These molecules then spread their energy throughout the rest of the food by conduction
23 of 85
List 5 methods of reducing energy loss in a house
Loft insulation, cavity wall insulation, double-glazed windows, thick curtains and draught-proofing
24 of 85
What is payback time?
The amount of time it takes for an energy saving device to pay itself off
25 of 85
How can a Thermogram be used to show energy wastage?
A thermal imaging camera turns infrared emission into an image showing where heat is escaping from a house with different colours depending on degree of emission to indicate what measures are needed
26 of 85
How is energy usage of a device shown?
A Sankey diagram
27 of 85
What is the equation for a device's efficiency?
Efficiency = (Useful energy output / Total energy input) x 100
28 of 85
A kettle is supplied with 180 000 J of electrical energy. 9000 J is wasted by heating surrounding air. What is the kettles efficiency
29 of 85
A light bulb has an efficiency of 5%. If 1000 J of useful light energy is given out, how much energy is wasted?
19 000 J
30 of 85
If a device has efficiency higher than 50%, which arrow on a Sankey diagram will be thickest?
The one pointing right (useful output)
31 of 85
List four measurable properties of a wave
Amplitude, frequency, wave length and speed
32 of 85
Define Amplitude
The perpendicular height of the wave to the normal
33 of 85
Define Frequency
The number of complete cycles (or oscillations) passing a certain point per second
34 of 85
Define Wavelength
The length of the full cycle of a wave e.g. crest to crest
35 of 85
How do you calculate a wave's speed?
Frequency (Hz) x Wavelength (m)
36 of 85
What Greek letter represents wavelength?
37 of 85
All waves can be...
Reflected, refracted and diffracted
38 of 85
What are the equivalents of crests and troughs in longitudinal waves?
Compressions and Rarefactions
39 of 85
Angle of incidence equals...
Angle of reflection
40 of 85
What is Total Internal Reflection?
When light hits a boundary of an optically less dense medium to the one it was in at an angle greater than the critical angle
41 of 85
What happens if the angle of incidence equals the critical angle?
The ray travels along the boundary with some internal reflection
42 of 85
What happens if the angle of incidence is less than the critical angle?
Most of the light leaves the medium but refracts away from the normal and some internally reflects
43 of 85
Define diffraction
A wave spreading out at the edges when passing through a gap
44 of 85
What happens when the gap is the same size as the wavelength?
Maximum diffraction
45 of 85
Define refraction
Different parts of the wave change at different times when going from media of different optic densities. This causes the wave to bend
46 of 85
When entering an optically more dense medium, which way does the wave bend?
Towards the normal
47 of 85
List the seven types of electromagnetic wave in order from largest to smallest wavelength
Radio waves, Microwaves, Infrared, Visible light, Ultraviolet, X-rays and Gamma rays
48 of 85
What effects can electromagnetic waves have when absorbed?
Heating and ionisation (if they have enough energy)
49 of 85
The properties of an electromagnetic wave depend on what?
Frequency and wavelength
50 of 85
Which waves tend to be more dangerous?
Higher frequency, short wavelength waves e.g. gamma because of high energy
51 of 85
Give advantages of communication by copper cable and fibre optics
Can carry multiple pieces of information at once quickly, no signal loss like wireless, more secure than wireless systems, bigger bandwidth available cheaply
52 of 85
Give advantages of wireless communication
Damaged cable can be expensive to repair and wireless is more practical over long distances, also makes devices portable
53 of 85
How does information travel through optical fibre?
Light signals are sent down the fibre in bursts to make a binary code. The light travels by Total Internal Reflection
54 of 85
What is multiplexing?
Several digital signals being sent down the same line at the same time in a sequence that can be decoded at the other end. This requires less cable and removes interference
55 of 85
Which types of EM waves are used for transmitting information over long distances?
Radio and microwave
56 of 85
How are short wavelength radio waves used in communication?
They can be reflected off the ionosphere to relay information from one part of the Earth's surface to another
57 of 85
How are longer wavelength radio waves used?
The can diffract (bend) around the Earth's surface and around obstacles like mountains
58 of 85
Which kind is used for FM radio and regular TV?
Short wave
59 of 85
Because they must have line-of-sight - little diffraction but can reflect
60 of 85
How can diffraction cause signal loss at receptor dishes?
Waves can spread out at he edges of a dish making the signal weaker
61 of 85
How exactly do radio waves 'reflect' off the ionosphere?
By refraction - waves speed up through ionoised particles so they bend back towards the Earth's surface
62 of 85
What type of EM waves are used to communicate with satellites?
63 of 85
Because their long wavelength means they aren't absorbed or scattered extensively when passing through the atmosphere
64 of 85
What else are they used for?
Mobile phones
65 of 85
Why are mobile signal masts placed on high ground and close together?
Because microwaves cannot diffract - must have line of sight
66 of 85
Why do some people think that living near telephone masts can damage your health?
Some studies suggest that absorption of microwaves can harm cells and cause mutations with prolonged exposure
67 of 85
What does LASER stand for?
Light Amplified by Stimulated Emission of Radiation
68 of 85
Give four properties of a laser
Monochromatic, in-phase, narrow beam, little divergence, coherent
69 of 85
How are lasers used to read CDs?
A laser is fired at the surface, reflects off pits and flats and returns to the receiver as a binary sequence
70 of 85
The size of a wave receiver is relative to what?
71 of 85
Bigger receiver relative to wavelength reduces signal loss by diffraction
72 of 85
Give three uses of infrared besides cooking
Controlling electrical devices e.g. TV remotes, motion sensor lights, thermal imaging, security systems
73 of 85
What's the difference between digital and analogue signals?
Analogue can have any value within a certain range, digital has only two values (on/off)
74 of 85
Give advantages of using digital signals
Multiplexing, interference doesn't affect quality
75 of 85
Give advantages of analogue signals
Usually higher quality due to range vary
76 of 85
Explain why Morse Code is a digital signal
It only has two values
77 of 85
What problems can UV radiation cause?
Skin cancer due to mutations and cataracts
78 of 85
What absorbs UV radiation to protect us?
The Ozone Layer
79 of 85
What does SPF stand for?
Sun Protection Factor
80 of 85
If someone can stay in the sun for 35 minutes without burning, how long can they stay in the sun with SPF 15 sun cream without burning?
8 hours 45 minutes
81 of 85
What has damaged the ozone layer in the past
Use of CFCs in refrigerators and aerosols deplete ozone
82 of 85
Describe P-Waves
Fast Longitudinal waves that travel through solids and liquids. Detected first around the Earth and refract through denser media
83 of 85
Describe S-Waves
Slower transverse waves that cannot travel through liquid and are detected second
84 of 85
How can we prove the outer core is liquid?
S-waves are not detected opposite the epicentre meaning they must travel through liquid
85 of 85

Other cards in this set

Card 2


What is heat measured in?



Card 3


Why is heat measured on an absolute scale?


Preview of the front of card 3

Card 4


Describe how heat flows


Preview of the front of card 4

Card 5


Define Temperature


Preview of the front of card 5
View more cards


No comments have yet been made

Similar Physics resources:

See all Physics resources »See all P1 resources »